A miniaturized, solid-phase nanoreactor was developed to prepare Sanger DNA-sequencing ladders which was directly interfaced to a capillary gel electrophoresis system. A biotinylated fragment of the rat brain actin gene (1 kbp) was amplified by PCR and attached to the interior wall of an (aminoalkyl)silane-derivatized fused-silica capillary tube via a biotin/streptavidin/biotin linkage. Coverage of the capillary wall with the biotinylated DNA averaged 77 +/- 10%. Stability of the anchored template under pressure (33 nL/s) and electroosmotic flows (11.3 nL/s) were favorable, requiring rinsing for > 150 h to reduce the surface coverage by only 50%. In addition, the immobilized template was stable toward temperatures required for preparing sequencing ladders, even under cycling conditions. Standard Sanger dideoxynucleotide termination performed in a large-volume (approximately 8 microL) solid-phase reactor using the thermally stable polymerase enzymes Taq and Vent and the polymerases T7 and Bst with off-line slab gel electrophoresis and autoradiographic detection indicated that acceptable fragment generation was achieved only in the case of the thermally stable polymerases. Banding was not apparent for T7 and Bst since all reagents were inserted into the column in a single plug at the beginning of the reaction. A small volume reactor (volume approximately 62 nL) was then used to perform DNA polymerase reactions and was coupled directly to a capillary gel column for separation. The capillary reactor was placed inside a thermocycler to control the temperature during chain extension and was directly connected to the gel column via zero dead volume fused-silica connectors. The complementary DNA fragments generated (C-track only) in the reactor were denatured using heat and directly injected onto the gel-filled capillary for size separation with detection accomplished using near-IR laser-induced fluorescence. Extension and single-base separation resolution of the C-track, which was directly injected onto the gel column, was estimated to be > 450 bases from the primer annealing site with plate numbers ranging from 1 x 10(6) to 2 x 10(6)/m.